of data needs to be rewritten to repair it. 3.39 GATEWAY MODULE DATA CALIBRATION The gateway control unit needs to be calibrated after replacing to repair inconsistencies, such as VIN. A "gateway" is designed between the two independent buses of the power system CAN and the body system CAN to recognize the resource sharing between each CAN and feed back the information of each data bus back to the instrument panel. EN 3.40 RAINFALL LIGHT SENSOR The rain sensor is used to adjust the automatic wiper frequency and the light sensor adjusts the light intensity of the automatic headlights according to the ambient light and darkness. This function can adjust the initial parameters.
3.41 TURBOCHARGING MATCHING Use this function for learning after replacement of the booster system components or after resetting turbocharger learning value. The parameters that affect the engine boost mainly include the air flow of the engine, the boost pressure ratio, the efficiency of the compressor, and the temperature of the engine exhaust gas. When replacing parts such as the turbine, its initial value must be reset, and if fine-tuning is required, some settings may be adjusted through this function. 4.
ADAS The Advanced Driver Assistance System (ADAS) is an electronic component in vehicles that includes a variety of vehicle safety functions such as automatic emergency braking (AEB), lane departure warning (LDW), lane keeping assistance, blind spot elimination, night vision cameras, and self-adaptive lighting. For this function, it is necessary to use the ADAS calibration device and activate ADAS software. 29