Mitsubishi — 3.12.2 Manual Modes

3 Functions of Devices in DVP-PM ◎ indicates that the register is applicable for the corresponding manual mode.

DVP-PM Application Manual 3-79 Manual Mode Registers for the Motion JOG Zero return Single-speed positioning Single-speed positioning interruption Externally triggering single-speed positionin 2-speed positioning 2-speed positioning interruption Variable speed MPG input X axis Y axis Z axi s A axis Parameter Name HW LW HW LW HW LW HW LW D1851 D1850 D1931 D1930 D2011 D2010 D2091 D2090 Current speed (CS) (PPS) ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ D1853 D1852 D1933 D1932 D2013 D2012 D2093 D2092 Current position (CP) (unit) ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ D1855 D1854 D1935 D1934 D2015 D2014 D2095 D2094 Current speed (CS) (unit) ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ D1858 D1938 D2018 D2098 Numerator of electronic gear - - - - - - - - ◎ D1859 D1939 D2019 D2099 Denominator of electronic gear - - - - - - - - ◎ D1861 D1860 D1941 D1940 D2021 D2020 D2101 D2100 Frequency of MPG input - - - - - - - - ◎ D1863 D1862 D1943 D1942 D2023 D2022 D2103 D2102 Number of accumulated MPG input pulses - - - - - - - - ◎ D1864 D1944 D2024 D2104 MPG response time - - - - - - - - ◎ D1865 Stop mode (OX0-99) - - - - - - - - - D1867 D1866 D1947 D1946 D2027 D2026 D2106 Electrical zero point - - - - - - - - - D1868 Setting up the No.

of OX - - - - - - - - - D1869 Error step of OX - - - - - - - - - D1872 Enabling Y output when OX is ready High byte: K1; low byte: designating start No. of Y output ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ D1873 Enabling Y output when OX executes M-code High byte: K1; low byte: designating start No. of Y output - - - - - - - - - D1874 No. of input point X for clearing OX M-code status - - - - - - - - - D1875 D1955 Enablel external input (ZRN, MPG, JOG-, JOG+) ◎ - - - - - - - ◎