5 Categories and Use of Basic Application Instructions API 36 Operands: S : Start No. of source device D : Start No. of destination device n 1 : Length of data to be shifted n 2 : Number of devices to be shifted as a group Explanations: 1. This instruction performs a right shift from source device of n 2 registers starting from S to destination device of n 1 registers starting from D . 2. This instruction is generally used in pulse execution mode (WSFRP). 3. The type of devices designated by S and D has to be the same, e.g. K n X, K n Y, K n M, and K n S as a category and T, C, and D as another category 4.
Provided the devices designated by S and D belong to K n type, the number of digits of K n in S and D has to be the same. 5. When specifying the bit device of KnX(Y/M/S), the starting No. should be a multiple of 16 in octal or decimal format. For example, K1X0, K4Y20 (octal); K1M0, K4S16 (decimal). 6. When WSFR is used as 16-bit instruction, Z device cannot be adopted; when WSFR is used as 32-bit instruction, V device cannot be adopted 7. Valid range of operand n1 , n2 : 1≤ n2 ≤ n1 ≤512 Program Example 1: 1. When X0 is triggered, WSFRP instruction shifts D10~D13 into data stack D20~D35 and D20~D35 also shift to the right with a group of 4 registers. 2.
The figure below illustrates the right shift of the registers in one scan. o D27~D24 → D23~D20 n D23~D20 → Carry p D31~D28 → D27~D24 q D35~D32 → D31~D28 r D13 ~D10 → D35~D32 completed X0 5 Carry Program Example 2: 1 2 3 4 DVP-PM Operation Instruction 5-54 Mnemonic Operands Function Controllers 20PM 10PM WSFR P Word Shift Right Type OP Bit Devices Word devices Program Steps X Y M S K H KnX KnY KnM KnS T C D E F WSFR, WSFRP: 9 steps S * * * * * * * D * * * * * * n 1 * * n 2 * * WSFRP D10 D20 K16 K4 D13 D12 D11 D10 D35 D34 D33 D32 D31 D30 D29 D28 D27 D26 D25 D24 D23 D22 D21 D20