6 Motion Instructions & G-Code Instructions MON 04 05 Operands: P 1 : Target position on X axis P 2 : Target position on Y axis P 3 : Target position on Z axis L : Radius of arc / helix (R = ”+“ when radian 180°) V : Arc/helical interpolation speed Explanations: 1. Maximum V = V MAX . 2. Range of parameters: (16-bit) K = -32,768 ~ 32,767; H = 0 ~ FFFF; D = 0 ~ 9,999; (32-bit) KK = -2,147,483,648 3. Acceleration/deceleration time and bias speed can be set up in special D. ~ 2,147,483,647; HH = 0 ~ FFFFFFFF; DD = 0 ~ 9,998. 4. Acceleration/deceleration time increases or decreases in proportional to the setting of V MAX . 5. 2-axis arc interpolation:
20D model only supports arc interpolation on X-Y plane. 20M model supports arc / helical interpolation on 3 planes by G-Code instructions: G17 (X-Y plane), G18 (X-Z plane) or G19 (Y-Z plane). See the figure below for X-Y arc interpolation +R Target point (P , P ) 1 2 Target point (P , P ) 1 2 -R Center -R +R Center Center Center Starting point (current position) Starting point (current position) CCW (Counterclockwise) CW (Clockwise) 6. 3-axis helical interpolation: Applicable to 20M model only. 3-axis helical interpolation is an advanced function to 2-axis arc interpolation. When a 3 rd axis is added to arc interpolation, a helical interpolation can be performed, i.e.
if the vertical value on Z axis is set to 0, the helical interpolation will simply perform 2-axis arc interpolation 7. The figure below illustrates the moving paths of the helical interpolation with and without the value on Z-axis. (G17 mode, X-Y plane). DVP-PM Application Manual 6-18 Mnemonic Operands Function X P CW / CCW 1 R Y P Z P 2 3 L F V Clockwise Arc / Clockwise Helical / Counterclockwise Arc / Counterclockwise Helical Movement (radius) Controllers 20PM - Type Bit Devices Double-Word Devices Notes K H D KK HH DD CW/CCW instruction supports V, Z index register modification on the devices. You can place an M-Code instruction after CW/CCW.
P 1 * * * * * * P 2 * * * * * * P 3 * * * * * * L * * * * * * V * * * * * *