7 Use DVP-PM As Slave 7.1 Access between DVP-EH2, DVP-PM (as Master) and DVP-PM (as Slave) When DVP-PM is used as Slave, there is a data exchange area in DVP-PM which corresponds to the control registers (CRs) in the Master. The data exchange area is consisted of consecutive special registers, and users can utilize the data exchange area for accessing data between Master and Slave as well as performing motion control functions through a Slave DVP-PM. 7.1.1 The Structure ‹ DVP-EH2 and Master DVP-PM apply FROM/TO instructions to transmit commands to Slave DVP-PM for executing motion control subroutines.
‹ DVP-EH2 and Master DVP-PM apply FROM/TO instructions to access the control registers (CR#0 ~ CR#199, corresponding to special registers D1500 ~ D1699 in the Slave) in Slave DVP-PM. Master Slave DVP-PM Application Manual 7-1 CR#0 ~ CR#199 DVP-EH2/DVP-PM Master accesses th by FROM/TO instru D1500 D1501~D1699 Model FROM/TO code data exchange area Users move the Special data to be exchang registers into data exchange . DVP-PM