Mitsubishi — 9.2.1.2 Set Terminal Polarity

9 Electrical CAM 9.2 E-CAM Application In electrical cam system of DVP-PM, we have to set up the master shaft (Master) which simulates mechanical cam, and also the slave shaft (Slave) which simulates the cam follower. In this section we will introduce the methods to obtain Master position and relationship between Master and Slave (E-CAM data). „ Structure Map Cam output „ Operation Process 9.2.1 Initial Settings 9.2.1.1 Set E-CAM Data „ There are 2 methods applicable for setting up E-CAM data in DVP-PM: Method 1: Use DTO instruction to create E-CAM data directly. Method 2:

Use E-CAM Chart of PMSoft to draw the CAM curve For detailed explanation on the setting methods of E-CAM data, please refer to section 9.4 9.2.1.2 Set Terminal Polarity „ Input Terminals 1. MPGA0/MPGB0: Pulse input terminal for Master. Max allowable frequency: 200kHz.

DVP-PM Application Manual 9-2 PG signal MPGA0+ MPGA0- MPGB0+ MPGB0- TART0/PG0 START0 (9) PG0 (6) Enable virtual Master DVP-PM (3) (5) (5) (4) (2) Set up Pulse Input Slave Output Set up pulse input magnification pulse mag- pulse Terminal input of Master output nification output polarity type type Enable Sync output (1) acyclic E-CAM E-CAM Data (resolution 10~2048) (8) (7) Enable Enable Or acyclic cyclic E-CAM E-CAM FP0+ FP0- RP0+ RP0- CLR0 CLR1 (3) Set up pulse input type Pulse input of Maste MPGA0+ MPGA0- MPGB0+ MPGB0- START0 PG0 STEP1 STEP2 STEP3 Initial Settings Select Source of Master Enable/Disable E-CAM (1) Set E-CAM data (2) Set terminal polarity (not applicable for virtual Master) (3)Set up input pulse type (4)Set up output pulse type (5)Input/output magnification z MPG z Encoder of Master servo z Output pulses of DVP-PM (6) Enable virtual Master (7) Enable cyclic E-CAM (8) Enable acyclic E-CAM