Mitsubishi — 9.3 Explanations on Special Flags and Registers

9 Electrical CAM Set up pulse input/output type as A/B phase D=H30 Set up D1799 (input terminal polarity setting)= 6. MPGA0/MPGB0 are NO contacts. Reset M1746. Acyclic E-CAM is triggered by START0 Enable STOP0/START0 as external input point Repeat E-CAM Data for 2 times Set up operation speed of Y axis variable speed operation When D1846=H4000, Y axis variable speed operation executes. When M0 is rising-edge triggered, set D1846=H4000 to enable acyclic E-CAM When M0 is falling -edge triggered, acyclic E-CAM stops 9.3 Explanations on Special Flags and Registers „ E-CAM max frequency: DD1840, M1749 1. D1841, D1840 (VI): E-CAM max frequency.

If the registers are not set up properly, output function will not operate normally. 2. M1749: E-CAM max frequency control M1749 = OFF, the Slave frequency will follow the Master frequency, but the max frequency will be 300kHz. Master Slave M1749 = ON, the max frequency of Slave will be specified by D1841, D1840(VI) Master Slave „ Enabling cyclic E-CAM / Completion of cyclic E-CAM:

D1846 / M1813 DVP-PM Application Manual 9-16 M1002 ZRST D1848 D1849 ZRST D1860 D1863 RST D1868 MOV K200 D1864 MOV H30 D1816 MOV K6 D1799 RST M1746 SET M1035 M1002 MOV K2 D1832 DMOV K2000 D1920 LD= D1846 H4000 MOV H10 D1926 M0 MOV H4000 D1846 M0 MOV H0 D1846 MOV H0 D1846 ZRST D1848 D1849 ZRST D1860 D1863 RST D1868 MOV K200 D1864 MOV H30 D1816 MOV K6 D1799 RST M1746 SET M1035 MOV K2 D1832 DMOV K2000 D1920 MOV H10 D1926 MOV H4000 D1846