Mitsubishi — 9.6.2.1 Rotary Cut

9 Electrical CAM 9.6.2 E-CAM Application on Rotary Cut and Flying Saw Devices The traditional material feeding and cutting applications apply go-and-stop pattern. The feeding control axis moves the material for a fixed distance and the cutting control axis performs the cutting process. In this pattern, feeding control axis repeats the move-and-stop actions while cutting control axis repeats cut-and-stop actions. Therefore, a go-and-stop working pattern is formed. However, the production efficiency of the pattern is low due to the deceleration and acceleration time generated in go-and-stop process.

Aiming at this problem, most current cutting applications apply continuous cutting patterns, such as rotary cut and flying saw, which have some difference with each other on E-CAM data design. Flying saw operates in reciprocating movements while rotary cut operates in the same direction. In addition, thick material cutting also works in the same direction as rotary cut. The difference between think material cutting and rotary cut is the E-CAM curve variation in cutting process. Unlike the constant proportion curve of rotary cut’s sync area, the E-CAM curve of thick material cutting varies during the cutting process between the start and the end of cutting.

The 3 E-CAM applications are explained as below. 9.6.2.1 Rotary Cut When the rotary cutter performs cutting action, the feeding conveyor does not slow down and stop. When the cutter touches the material, the moving speed of cutter should be the same as that of the feeding conveyor. If the cutter is slower than the conveyor, the material will be squeezed and piled; if the cutter is faster than the conveyor, the material will be extended and damaged. The operation and simple wiring of rotary cut is illustrated as below. Positions 1, 2, 3 and 4 respectively indicate starting posiiton, middle position, end position and ready position of speed synchronization.

When Master (Y axis) executes, Slave (X axis) accelerates from position 4 to position 1, reaching the synchronizing speed. The sync speed is maintained from position 1 to position 3. After position3, Slave decelerates and returns to position 4. The cycle repeats for continous rotary cut operation. DVP-PM Application Manual 9-64 (mm/pulses) Settings Winding shaft (Master/Y axis) Length of single speed positioning (pulses) =N2 x B = 100 x 3600 = 360000 Master= Coil shaft (Slave/X axis) Master (pulses) Max =2 x N1 x B = 2 x 20 x 3600 = 144000 Master “2” indicates double layer winding Slave (pulses) max =N1 x D/C = 20 x 0.3 / (0.1/100) Slave =6000