9 Electrical CAM 9.6.2.2 Flying Saw When the flying cutter performs cutting action, the feeding conveyor does not slow down and stop, and the moving speed of cutter should be the same as that of the feeding conveyor. In addition, the synchronizing time should be long enough for the cutter to finish the cutting process and return to the safe position. The Slave (E-CAM) controls the cutter as well as the whole cutting device to move forward and back and synchronize with the Master (conveyor) during cutting process. The operation and simple wiring of flying saw is illustrated as below.
Positions 1, 2, 3 and 4 respectively indicate starting posiiton, sync-start position, sync-end position and ready position. When Master (Y axis) executes, Slave (X axis) accelerates from position 1 to position 2, reaching the synchronizing speed. The sync speed is maintained from position 2 to position 3. After position3, Slave decelerates in reverse direction and returns to position 4 (Same as position 1). The cycle repeats for continous flying saw operation.
SyncOut 4 SERVO SERVO SERVO SERVO 1 2 3 blade Cut Length Cut Length Cut Length Cut Length 20PM 20PM Encoder output Encoder output CAM CAM CAM CAM SERVO SERVO SERVO SERVO X axis X axis Jog Jog Jog Jog Y axis Y axis „ Create E-CAM Curve In E-CAM design process, PMSoft creates E-CAM data by operating displacement data to generate the velocity data and the acc data. However, in this case we need to control the velocity between Slave and Master. To obtain the velocity, we can input the velocity data in the displacement table for creating the velocity curve.
After the velocity curve is created with displacement and acc curve, export the velocity data by clicking “Export” and import the velocity data by clicking “Import Speed Data”, so that the velocity relationship between Slave and Master can be obtained. 1. Set the max resolution as 200. DVP-PM Application Manual 9-68