Mitsubishi — 11.3.2 Storage of G/M code

11 G-code Application The program in O100 is listed as the diagram(B) Step 1: M1 = ON, set up work modes of 3 axes. (1) D1847=H1000 (2) D1927=H1000 (3) D2007=H1000 Step 2: M2 = ON, load the data in OX0 into CAM chart-0: (1) Select OX0 by setting D1868 = H4000. (2) Load the data in OX0 into CAM chart-0 Step 3: M7 = ON, execute OX0 (The data source is in CAM chart-0) (1) Select OX0 by setting D1868 = H4000. (2) Enable cyclic E-CAM 11.3.2 Storage of G/M code In this function, data in OXn is loaded to the corresponding CAM chart, and only G00, G01, G04 and M codes applied in “With mode” are supported for this function. The below diagram explains the data allocation in CAM chart.

DVP-PM Application Manual 11-22