3 Functions of Devices in DVP-PM 3.1 Devices in DVP-PM „ Function Specifications: DVP-PM Application Manual 3-1 Specifications Note 20PM 10PM 2-axis synchronous linear/arc 4-axis synchronous interpolation Control system interpolation and independent 2-axis and 4-axis independent control control (*5) Program storage Built-in 64k steps storage device Combined Machine system Control units Motor system (pulse) system(pulse/length) (length) Access CR (Control register) of the I/O module by FROM/TO instructions. Access method for I/O module System uses 2 CRs for 32-bit data.
When used as an I/O module, MPU accesses the built-in CR0 ~ CR199 (maps Serial connection with MPU to D1500 ~ D1699) of DVP-PM Pulse output system Differential output in 3 modes: Pulse/Dir, FP(CW) / RP(CCW), A/B phase Maximum speed For single axis: 500K PPS. For interpolation axis:
500K PPS AUTO/MANU (auto/manual switch), Operation switch STOP/RUN (auto/manual switch) START, STOP DOG, LSP (positive limit), LSN (negative X0, X2, X4, X6 (DOG signal) Input signal Detector limit), PG0 (zero point) X1, X3, X5, X7 (Zero point signal) General input X0 ~ X7, expandable up to 256 points (MPU + I/O module) point Y10+, Y10-, Y12+, Y12-, Y14+, FP (forward pulse), RP (reverse pulse), Y14-, Y16+, Y16- (forward pulse) Servo output CLR (clear signal) Y11+, Y11-, Y13+, Y13-, Y15+, Y15-, Y17+, Y17- (reverse pulse) Output signal General output Y0 ~ Y7, expandable up to 256 points (MPU + I/O module) point COM1: RS-232 (Slave only); COM2: RS-485 (can be Master or Slave) COM port COM3:
Optional RS-232 / RS-485 communication card (Slave only) Extended Shares all right-side modules with DVP-EH2 including AD, DA, PT, TC, XA, Special I/O PU, etc (maximum 8 modules expandable). modules will Optional not occupy module The left side of MPU can connect to high-speed I/O modules (maximum 8 any digital I/O modules extendable). points. Basic instruction 27 27 Application instruction 130 130 Motion instruction 22 z M02: End of OX0 ~ 99 motion subroutine M -Code z M00 ~ M01, M03 ~ M101, M103 ~ M65535: used as pause of the program, can be applied acccroding to actual needs. z M102:
End of O100 main program G0 (hi-speed positioning), G1 (linear interpolation), G2 (clockwise arc interpolation), G3 (counter-clockwise arc G-Code N/A interpolation), G4 (pause), G17(X-Y plane), G18(X-Z plane), G19(YZ plane), G90 (absolute positioning), G91 (relative positioning) Self-diagnosis Displaying errors such as parameter error, program error and external errors