The four elements in the above illustration are described below: • IPv6 Booting Device—The device that is booting through iPXE boot. • Supporting Device—A Cisco device that is configured with an IPv6 address to generate Router Advertisement (RA) messages. Note In this illustration, the IPv6 booting device, the supporting device, and the DHCP server are on the same subnet. However; if the supporting device and the DHCP server are on different subnets, then there must be a relay agent in the network. • DHCP server—Any DHCP server. • Web server—Any web server. This section describes the IPv6 iPXE boot process: 1.
The device sends a router solicitation Internet Control Message Protocol IPv6 (ICMPv6) type 133 packet to the IPv6 device on the local subnet. 2. The IPv6 device on the local subnet replies with a router advertisement (RA) message, ICMPv6 type 134 packet. The device that sent the router solicitation message, gets the default router and prefix information for Stateless Address AutoConfiguration (SLAAC) address completion from the RA packet. Provisioning IPv6 iPXE Network Boot Programmability Configuration Guide, Cisco IOS XE 17.16.x 89