2. Stateless Address Auto-Configuration (SLAAC) address 3. Link-local address 4. Site-local address The device uses the DHCP server-assigned address to boot an image. If the DHCPv6 server fails to assign an address, the device tries to use the SLAAC address. If both the DHCP server-assigned address and the SLAAC address are not available, the device uses the link-local address. However, the remote FTP/HTTP/TFTP servers must be on the same local subnet as that of the device for the image copy to succeed. If the first three addresses are not available, the device uses the automatically generated site-local address.
Supported ROMMON Variables The following ROMMON variables are supported in Cisco IOS XE Fuji 16.8.1: • BAUD: Changes the device console BAUD rate to one of the Cisco standard baud rate; such as 1200, 2400, 4800, 9600, 19200, 38400, 57600, and 115200). Any invalid value will be rejected. If the BAUD variable is not set, the default will be 9600. The corresponding CLI command is • ENABLE_BREAK: Enables a rommon break. The default value is NO. • MANUAL_BOOT: If manual boot is set to 1, the rommon or device prompt is activated. If manual boot is set to 0, the device is reloaded; but rommon mode is not activated. • SWITCH_IGNORE_STARTUP_CFG:
If the value is 1, it causes the device to ignore the startup configuration. If the value is not set, the value is treated as zero. This is a read-only variable, and can only be modified by IOS. iPXE-Supported DHCP Options iPXE boot supports the following DHCPv4 and DHCPv6 options in rommon mode. Catalyst 9000 Series Switches support DHCP Option 60, Option 77, DHCPv6 Options 1, Option 15, and Option 16. DHCP Option 61 is only supported on Catalyst 9300 and 9500 Series Switches. Note • DHCP Option 60—Vendor Class Identifier. This option is populated with the value of the ROMMON environment variable MODEL_NUM. • DHCP Option 61—Client Identifier.
This option is populated with the value of theROMMON environment variable SYSTEM_SERIAL_NUM. This option is not supported on Catalyst 9400 Series Switches. Note • DHCP Option 77—User Class Option. This option is added to a DHCP Discover packet, and contains the value equal to the string iPXE . This option helps to isolate iPXE DHCP clients looking for an image to boot from a DHCP server. Provisioning Supported ROMMON Variables Programmability Configuration Guide, Cisco IOS XE 17.16.x 91