"http://[2001:DB8::46]/platform-pxe/host1/17jan-polaris.bin"; The table below describes the significant fields shown in the display. Table 4: Sample Output Field Descriptions DHCPv6 Unique Identifiers There are three types of DHCPv6 Identifiers (DUIDs) defined by RFC 3315; these are: • DUID-LLT—DUID Link Layer address plus time, this is the link layer address of the network interface connected to the DHCP device plus the time stamp at which it is generated. • DUID-EN—EN stands for Enterprise Number, this DUID is based on vendor-assigned unique ID. • DUID-LL—DUID formed using the Link Layer address of any network interface that is permanently connected to the DHCP (client/server) device.
Cisco devices that support this feature use the DUID-EN (DUID Type 2) to identify the DHCP client (that is the device in the DHCPv6 Solicit packet). Catalyst 9000 Series Switches support not only DUID-EN, but also DUID-LL (DUID Type 3). DUID-EN is the preferred type; however, if switches are unable to create it, then DUID-LL is constructed and used. How to Configure iPXE Configuring iPXE SUMMARY STEPS 1. enable 2. configure terminal 3. boot ipxe forever [ switch number ] boot ipxe timeout seconds [ switch number ] 4. boot system { switch switch-number | all } { flash: | ftp: | http: | usbflash0 | tftp: } 5.
end Provisioning DHCPv6 Unique Identifiers Field Description dhcp6.client-id DHCP Unique Identifier (DUID) to identify the client. dhcp6.user-class DHCPv6 Option 15, the User Class option dhcp6.vendor-class-data DHCPv6 Option 16, the Vendor Class option that contains the switch Product ID (PID). dhcp6.bootfile-url DHCPv6 Option 6 to request for the Boot File URI Programmability Configuration Guide, Cisco IOS XE 17.16.x 93