DETAILED STEPS Procedure Configuring Device Boot You can either use the no boot ipxe or the default boot ipxe command to configure device boot. SUMMARY STEPS 1. enable 2. configure terminal 3. no boot ipxe default boot ipxe 4. end Provisioning Configuring Device Boot Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. • Enter your password if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 • boot ipxe forever [switch number] • boot ipxe timeout seconds [switch number] Example: Device(config)# boot ipxe forever switch 2 Example:
Device(config)# boot ipxe timeout 30 switch 2 Configures the BOOTMODE rommon variable. • The forever keyword configures the BOOTMODE rommon variable as IPXE-FOREVER. • The timeout keyword configures the BOOTMODE rommon variable as IPXE-TIMEOUT. Step 4 boot system {switch switch-number | all} {flash: | ftp: | http: | usbflash0 | tftp:} Example: Device(config)# boot system switch 1 http://192.0.2.42/image-filename or Device(config)# boot system switch 1 http://[2001:db8::1]/image-filename Boots an image from the specified location. • You can either use an IPv4 or an IPv6 address for the remote FTP/HTTP/TFTP servers.
• You must enter the IPv6 address inside the square brackets (as per RFC 2732); if not the device will not boot. Step 5 end Example: Device(config)# end Exits global configuration mode and returns to privileged EXEC mode. Programmability Configuration Guide, Cisco IOS XE 17.16.x 94