cisco IOS XE 17.16.x — Troubleshooting Tips for iPXE

Troubleshooting Tips for iPXE This section provides troubleshooting tips. • When iPXE boot is enabled on power up, the device first attempts to send a DHCPv6 Solicit message, followed by a DHCPv4 Discover message. If boot mode is ipxe-forever the device keeps iterating between the two forever. • If the boot-mode is iPXE timeout, the device first sends a DHCPv6 Solicit message, and then a DHCPv4 Discover message, and the device falls back to device boot after the timeout expires. • To interrupt iPXE boot, send a serial break to the console. When using a UNIX telnet client, type CTRL-] and then send break.

When you are using a different TELNET client, or you are directly attached to a serial port, sending a break may be triggered by a different keystroke or command. • If the DHCP server responds with an image, but the DNS server cannot resolve the hostname, enable DNS debugs. We recommend the use of ISC DHCP server. This feature has not been verified on IOS DHCP. Note • To test the HTTP server connectivity, use HTTP copy to copy a small sample file from your HTTP server to your device. For example, at the rommon prompt, enter copy http://192.168.1.1/test null: (the flash is normally locked and you need to use the null device for testing) or http://[2001:db8::99]/test .

• When manual boot is enabled, and boot mode is ipxe-timeout, the device will not automatically boot on power up. Issue the boot command in rommon mode. To automate the boot process on power up, disable manual boot. • Use the net6-show command to display the current IPv6 parameters, including IPv6 addresses and the default router in rommon mode On Catalyst 9000 Series Switches, use the net-show show command. Note • Use the net-dhcp or the net6-dhcp commands based on your configuration, The net-dhcp command is a test command for DHCPv4 and the net6-dhcp command is for DHCPv6. On Catalyst 9000 Series Switches, use the net-dhcp -6 command for DHCPv6. Note • Use the dig command to resolve names.

On Catalyst 9000 Series Switches, use the dns-lookup commmand to resolve names. Note Provisioning Troubleshooting Tips for iPXE Programmability Configuration Guide, Cisco IOS XE 17.16.x 98