Topdon — PulseQ AC Mini User Manual

Section 7 - Fault Handling When a fault occurs, the charging status indicator will alternatively blink green (once) and red (1~11 times), then repeat. Indicator Status Fault Code Fault Description Suggestion 1 red blink E001 LN reverse polarity or Check if the input power cable is ground fault correctly connected or the ground wire is securely connected. 2 red blinks E002 Relay sticking Contact after-sales service . (Charger components may be damaged and need to be replaced.) 3 red blinks E003 Relay rejection fault Contact after-sales service.

(Charger components may be damaged and need to be replaced.) 4 red blinks E004 Input overvoltage Power grid failure, wait until the input voltage is automatically recovered. 5 red blinks E005 Output overcurrent Contact after-sales service. (This may be caused by faulty charging cable or output short circuit.) 6 red blinks E006 Overtemperature Check if the temperature of the charger is too high. Stop charging and wait until the temperature is dropped. 7 red blinks E007 Leakage Contact after-sales service. (Charger components may be damaged and need to be replaced.) 40