Topdon — PulseQ AC Mini User Manual

RFID Reader Mode When in the RFID Reader mode, you need to use the supplied charging card to control the start / stop of charging. Step 1 Get a Type 2 male to Type 2 female cable (not included) designed for detachable connection (Case B). Insert the male end of the Type 2 cable into the charger's charging socket, then connect the female end to the vehicle's inlet. Step 2 Touch the supplied card on the charger to start charging. You will hear a beep sound when charging starts. Step 3 Remove the female side from the vehicle inlet, then the male side from the charger when charging is finished. Note: 1) During the charging process in both modes, the charging plug is locked to prevent unplugging.

To stop charging prematurely, use the supplied card or stop charging at the vehicle end. 2) To toggle between the two charging modes, touch the supplied charging card on the charger for more than 5 seconds (until a beeping sound is heard). 39