Руководство по эксплуатации G5 Omron серво привод (EN)

G5 Using Safety Quick Start Guide This guide discusses how to connect and program the G5 servo drive to NX safety. Description 1. Items needed: a. Users Manual, found at www.omron247.com . b. Safety Control Units User’s Manual Z930, found in help section of Sysmac Studio. 2. There are no force guided relays to turn all safety devices on since the Omron G5 servo drive is rated for direct safety connection. Remove Jumpers 1. Locate jumper, labelled CN8Safe. Remove this on all G5 servo drives. 2. Removing jumpers by hand can cause the latch to break. Recommended practice is to use a screw driver. The latch is on the left side. Document: QSG-G5-TO-NX-SAFETY - Version 1.0 Feb 14, 2014 Page 1 of 4

Стр. 1

3. Plug in R88A cable(s) – one per servo drive. 4. Up to 4 G5 servos drives can be daisy chained. Add EtherCAT cable to connect. Wiring SOD400 SID800 So0 So1 So2 So3 Si0 Si1 G G output G G T0 T1 (orange) inputs (white) (black) (red) SF1+ SF1- SF2+ SF2- SF1+ SF1- SF2+ SF2- SF1+ SF1- SF2+ SF2- SF1+ SF1- SF2+ SF2- EDM+ EDM- EDM+ EDM- EDM+ EDM- EDM+ EDM- (blue) (green) EDM signals from Servo Drive G5 (Safety built in so direct connection) (Colors using R88A-CSK003S-E cable) Document: QSG-G5-TO-NX-SAFETY - Version 1.0 Feb. 14, 2014 Page 2 of 4

Стр. 2

Parameter / Node Multiview explorer -> Select Safety CPU -> Configuration and setup -> Communications -> Safety -> Safety I/O -> Select a node -> double click on parameters -> click on the white X next to the filter to see all of the nodes -> use toolbox to select a safety device (might need to drag right side window to see the toolbox) -> drag and drop parameter to knob -> complete for all nodes. Note: The fields in the nodes are not used in the program. Could be used to enter part name/type/number.

(Input) Mechanical contact for single channel (Output) Dual output with test pulse I/O Map Multiview Explorer -> select Safety CPU -> Configurations and Setup -> double click on I/O Map -> make sure arrown buttons are all pointing down -> use variable template to paste (Note: It will not paste if there is an empty field. Can only do groups when no empty fields.) OR manually enter with right click OR scroll down to highlight all variables -> right click -> select variable. (Note: Do not enter a variable name for the second input or output of dual channel devices.) Document: QSG-G5-TO-NX-SAFETY - Version 1.0 Feb. 14, 2014 Page 3 of 4

Стр. 3

Program Use the EDM safety function block. Multiview Explorer -> select new_safetyCPU -> Programming -> POU -> Programs -> Program0 Power Supply Best Practice Servo brake and I/O should be on separate power supplies. Sharing can cause noise on the I/O lines when the brake is applied. Use separate power supplies for the coupler and the I/O devices. Document: QSG-G5-TO-NX-SAFETY - Version 1.0 Feb. 14, 2014 Page 4 of 4

Стр. 4