Ramsey UT5A — Ramsey UT5A Ultimate 555 Timer Kit Manual — User Guide PDF

SETUP Monostable Mode: 1. Install a Shorting Block across pins 1 & 2 of JMP6. 2. In the Monostable mode the timer needs an input. Install a Shorting Block across both pins of JMP4. 3. Connect the source circuit to J2. Connect the input to J2 pin 1 if the signal is a positive going pulse or pin 3 if it is a negative going pulse. Connect the ground of the source circuit to J2 pin 2. If the input signal is a square wave or a wide pulse you can select which edge of the waveform you wish the timer to trigger. If you wish to trigger on the positive going transition connect to pin 1 if the negative going transition connect to pin 3. 4. Your input circuit may need a pull-up resistor.

If the source circuit provides both a high and low the pull-up will not be needed so remove the Shorting Block from JMP2. If the input circuit provides a contact closure or open/closed path for current then you will need the pull-up resistor. Place a Shorting Block on the pins of JMP2. 5. If the input signal is a square wave or wide duration pulse you will probably need the signal to be differentiated. This prevent the input signal from interfering with the timing of the timer. Remove the Shorting Block from the pins of JMP3 to activate the differentiator circuit. If it is required that the differentiator be disabled install a Shorting Block across JMP3’s pins.

This Shorting Block will normally not be installed 6. Verify that R4, R5, and C2 are the proper values to give the timing you require. Astable Mode: 1. Install a Shorting block across pins 2 & 3 of JMP6. 2. Typically a in the Astable mode an input is not required. Remove the Shorting Block from JMP4. This removes R3 and R1 from C2’s charge path with JMP6 jumped pins 2 to 3. 3. Verify that R4, R5, R6, R7 and C2 are the proper values to give the timing you require for both Pulse Width and Rest Time. Control Voltage Configuration: 1. For no Control Voltage remove the Shorting Block from JMP5 and leave J3 pin 1 open. UT5A  22