FAULT : Wrong Frequency Range in Astable mode SOLUTIONS: Insure JMP4 is removed Insure JMP5 is removed and no Control Voltage is applied FAULT : Unit will not start when S1 is pressed in Monostable Mode SOLUTIONS: Verify JMP2 is installed Verify JMP4 is installed FAULT : Output signal matches the input square wave SOLUTIONS: Remove JMP3 to install the differentiator If you are still unable to solve your kit problems you may send your kit in for repair. For instructions on how to return kits for repair please see the “Factory Repair of Assembled Kits” section of our Ramsey Kit Warranty page on the inside back cover of this manual. You may also contact our Technical Support Department at :
Phone: (585) 924-4560 Email: techsupport@ramseyelectronics.com Address: Ramsey Electronics, LLC Attn. Hobby Kit Department 590 Fishers Station Drive Victor, NY 14564 UT5A 25