• Slide short lead (15) on to threaded pin. • Install cover (11). • Attach lead (1). 12.9 7 4 8 1 5 6 14 2 10 11 9 3 13 15 12 RS120080 Dismantling/reassembling starter Checking starter motor motor • Test with MoDiTeC. • Detach lead (1). Checking starter relay • Remove retaining screws (2). • Remove flange (3). • Test with MoDiTeC. • Remove solenoid switch (4) after taking out the retaining screws (5). • Remove release lever (6) and spring (7) from so- lenoid switch (8). • Remove retaining ring (9) and take starter motor gear assembly (10) off shaft. • Install by following the above work instructions in the reverse order. • Coat the helical thread and pull-in ring with grease.
Lubricant:......................... Bosch PZ 2 V 3 silicone grease or equivalent Renewing carbon brushes • Detach lead (1). • Remove cover (11). • Remove holder (12) for carbon brushes. • Lift up retaining springs (13) and remove carbon brushes (14). • Install carbon brushes with retaining plate. 2 9 3