Delta Electronics — 8.4.1 Parameters in a Module

Chapter 8 Hardware Configuration 8.4 Setting Parameters in a Module 8.4.1 Parameters in a Module You can set the parameters in every module configured in HWCONFIG. The functions and characteristics of every module depend on the parameter settings. To set the parameters in a module, double-click the module in the system configuration area to open the Device Setting dialog box. This dialog box may be different for each of the various devices. The parameters are set according to the functions supported by the module. Before you set the parameters, refer to the Operation Manual for more information.

To prevent damage to the system or personnel, check the effect of the parameters on the module and the entire system. There are two tabs Device Setting dialog box: the Device Information tab and the Normal Exchange Area tab. Click the Device Information tab to display the module information, appearance, and present DDF document version. _8 The number of parameters that you can set in the module and the range of setting values depend on the version of the DDF document. The firmware and hardware version of the CPU module also appear when all the modules are connected online. 8-49