Delta Electronics — 9.4.1 Run the EIP Builder

AS Series Operation Manual 9.4 EIP Builder The Delta EtherNet/IP software, EIP Builder, is embedded in ISPSoft. You run it from the ISPSoft software (version 3.0 and above). Download the ISPSoft software at: http://www.deltaww.com/services/DownloadCenter2.aspx?secID=8&pid=2&tid=0&CID=06&itemID=060301&typeID=1&d ownloadID=,&title=--%20Select%20Product%20Series%20--&dataType=8;&check=1&hl=en-US 9.4.1 Run the EIP Builder You can call EIP Builder from Delta EIP Scanner’s HWCONFIG in ISPSoft. You can also call it independently to set up parameters for the Adapter. The Delta EIP Scanner is equipped with the EtherNet/IP communication PLC and the EtherNet/IP module.

Refer to Section 9.9.3 for a list of Delta EIP Scanner products supported by EIP Builder. 9.4.1.1 Run the EIP Builder via an EIP Scanner  Steps to run EIP Builder Run EIP Builder from an EIP Scanner product. When using a Delta EIP Scanner, you set up an EIP module through HWCONFIG in ISPSoft. Make sure the current communication is via EtherNet in ISPSoft. Start Open I SPSoft V3 0X . Create I SPSoft Project Open HW CONF IG Download HW CONF IG Open EI P Builder 1. Open ISPSoft V3.0X: click the Start menu and go to Programs > Delta Industrial Automation > PLC > ISPSoft 3.0X 2. Create a new project: on the File menu, click New to display the Create a New Project dialog box. _9 9-14