Chapter 12 Troubleshooting 12_ 12-29 ERROR LED indicator status Error CPU Description code status Blinking Blinking Blinking ON OFF fast normally slowly 1607 The external voltage is abnormal. Stop V 1608 The Internal factory calibration or the CJC is abnormal. Stop V 1609 - 160F Reserved (Error codes for the extension modules) Stop V 1800 - 180F Errors occurred in the extension modules Continue V 1900 - 191C Heartbeat errors occurred in the slave of the Delta ASD-A2 control. Continue V 1950 The initialization of the Delta ASD-A2 control has not yet been completed, the CANopen instructions cannot be executed.
Continue V 2001 Not using the FCOMP card or not in the right mode for the ASDA-A2 while using the CANopen communication instruction. Continue V 2003 The device used in the program exceeds the device range or is illegal. Continue V 200A Invalid instruction Stop V 200B The operand n or the other constant operands K/H exceed the range. Continue V 200C The operands overlap. Continue V 200D The binary to binary-coded decimal conversion is incorrect. Continue V 200E The string does not end with 00. Continue V 2012 Incorrect division operation Continue V 2013 The value exceeds the range of values which can be represented by the floating-point numbers.
Continue V 2014 The task designated by the TKON or YKOFF instruction is incorrect, or exceeds the range. Continue V 2017 The instruction BREAK is written outside of the FOR-NEXT loop. Continue V 2027 No such position planning table number or the format is incorrect. Continue V 2028 The high speed output instruction is being executed. Only one instruction can be executed at a time. Continue V 2030 During the execution of CSFO instruction, the output frequency exceeds the upper limit. Continue V 2031 During the execution of CSFO instruciotn, when the output frequency is set to 0, but even after 2 seconds, the output is still not complete.
Continue V 6004 The IP address filter is set incorrectly. Continue V