RIEVTECH STUDIO SOFTWARE MANUAL The properties of “ Width ” and “ Height ” are used to set the width and the height of the component. If the option is grey and not editable, it represents the attribute is not available. It is shown as below. If you check the option “ Locked ” , the position of the component will be locked. Its position and size cannot be edited. A lock mark will display in the upper left corner of the component when you select it in the configuration window. 4.13.13 Rotation The function of “ Rotation ” can adjust the display angle of the components such as static graphics, vector graphics and other components.
This function is a static function.That is, the display angel is not adjusted in the HMI if you set the display angle in the “ Rotation ” property. If you want to dynamically adjust the display angle of the graphics, please refer to: Detailed manual/General functions/Dynamic Graphics . 1 Fix Point Each figure has nine fixedpoints. The middle fixed point is selected as the default by the system. You can change the fixed point. The result is different after the figure rotates around the different fixed point. For example, a rectangle rotates the center fixed point and another rectangle rotates the upper left fixed point. It is shown as below. 537