• Using VE-Series Voice Expanders If you have a VE-Series Voice Expander installed, the sequencer’s MIDI THRU Condition (MIDI-3) determines whether the keyboard will sound the Internal Performance, the Voice Expander or both. • Customizing Patches cont. 5) The s and t in the display indicate additional parameter windows. You can cursor to related parameters from any of the eight Edit Palette screens. To set the MIDI THRU Transmit condition: 1) Press MIDI in the sequencer section. 2) Press 3, then press ENTER. 3) Set the desired sound source. To store your new Patch in memory: 1) Press WRITE. 2) Cursor to Write and press ENTER.
3) Select a User Patch location using the Patch Group, Bank and Number buttons, or slider 1. 4) Press ENTER. THRU OUT 1: JV Internal Performance THRU OUT 2: Voice Expander THRU 1 + 2L Both Internal and V-EXP • Using Performances Performances are the eight-Part multitimbral setups in the JV-1000. Like Patches, there are both Preset and User Performances available. Likewise, Sequencer Output Assign (Function 11) determines whether the sequencer Tracks plays the Internal Performance, the Voice Expander, or both. Each Track can have its own output assignment. 1) Press PERFORMANCE. 2) In the PATCH GROUP select USER or PRESET. 3) For Preset Performances: Select A, B, C, or D from the PATCH GROUP.
For User Performances: Select INT or CARD from the PATCH GROUP. 4) Use the Bank and Number buttons to choose a Performance. To assign the output of a Track: 1) Press FUNCTION. 2) Use the ALPHA-DIAL to select “FUNC11 OUTPUT ASSIGN,” and press ENTER. The numbers in the lower right corner of the display represent Tracks 1-8 and R. The default setting is both sound sources (3). 3) Use the ALPHA-DIAL and cursors to set each Track to the desired Output Assignment. The possible settings are: OFF: No data is output from the Track OUT 1: Data is sent to Internal Performance OUT 2: Data is sent to the V-EXP. 1+2: DATA is sent to both the Internal Performance and the V-EXP. 4) Press STOP.
There are three types of Performances: LAYER: For layering Patches ZONE: For splitting Patches across the keyboard SINGLE: For multitimbral sequencing. A Word about the Expansion Boards The JV-1000 can be expanded with one Voice Expander and one Wave Expander. • Customizing Patches with the Edit Palette The Edit Palette provides a quick, intuitive method for mastering the JV-1000’s powerful synthesizer controls. Each Patch combines from 1 to 4 Tones, indicated by the Tone Switch LEDs. The SR-JV80-Series Wave Expanders add 8 Mb of additional waveforms and Patches to the JV-1000. These Waves and Patches can be used in Patch or Performance Mode. 1) Press PATCH.
2) Press LEVEL in the EDIT PALETTE. 3) Use sliders 1–4 to remix the Levels of the enabled Tones. 4) Press the other EDIT PALETTE controls, PAN, TUNE, WAVE, CUTOFF, RESONANCE, ATTACK or RELEASE, and use the sliders to change the sound. The VE-Series Voice Expanders add an additional 28 voices of polyphony, hundreds of sounds, additional multitimbral Parts, plus digital effects for use by these Parts. Note : The added polyphony is used only by the Voice Expander Parts. Adding a VE-Series Voice Expander does not increase the polyphony of the Internal Performance. TBS16 © 1994 Roland Corporation U.S., 7200 Dominion Circle, Los Angeles, CA 90040 Faxback # 20050 6/95 NQPSMTR® ) FD:4 *@C