ROLAND — Back Cover

• Recording a Phrase Sequence • Saving to a PCMCIA Flash RAM Card Besides being able to sample directly to the Flash RAM card, you can also store your internal sounds and sequences to Back Up Files on the Flash RAM card. 1) Press the FUNCTION (SEQ) button to enter the sequence mode. 2) Press one of the four upper pads to select a sequence. 3) Press the REC button to enter record mode (recording will actually begin the moment a pad is pressed). 4) Press the REC button, again, to stop recording. 1) Press the EDIT UTILITY button. Use the buttons to select “Save? :BUF1.” This will save what is currently in memory into the first back up file location on the disk.

2) The “+ and —” buttons are used to select the correct backup file. 3) Press the (REC) YES button to save the data. • Playback a Sequence 1) Press the FUNCTION (SEQ) button to enter sequence mode. 2) Press one of the four upper pads( labeled Seq 1-4) to select a sequence for playback. 3) Press the PLAY pad to play the sequence. 4) The sequence will stop when it reaches the last recorded bar, or you can press the STOP button. 5) Pressing the reset pad will return the sequence to the beginning. NOTE: When you press pad 8 ( the repeat pad), the sequence will repeat until the STOP pad is pressed. • Loading from a PCMCIA Flash RAM Card 1) Press the EDIT UTILITY button.

Use the buttons to select “Load? :BUF1.” 2) The “+ and —” buttons are used to select the correct backup file. 3) Press the (REC) YES button to load the data. This will overwrite what is currently in the A and B banks. • Setting the Sample Grade The Sample grade will affect audio quality and sampling time length. You can select between High (44.1Khz), Standard (32Khz), Long 1 (22.05Khz) and Long 2 (16Khz). The higher the quality the shorter the sampling time. About Flash RAM The MS-1 uses Flash RAM PCMCIA cards available from SunDisk. Cards are available in 1.8 Mb, 2.5 Mb, 5 Mb, 10 Mb and 20 Mb sizes. Contact your local Roland dealer, or Roland Corporation U.S., for additional details.

At STANDARD Sample Grade, these cards will add about 75 seconds per Mb. 1) Press the EDIT SYSTEM button. Use the to access the Grade parameter. 2) Press the +/– buttons to select the desired grade of sampling. 3) Press EXIT to return to Pad Mode. • Formatting a Memory Card 1) With the power OFF, insert the card into the card slot, and turn the power on. 2) Press the EDIT UTILITY button. Use the “+ and –” buttons to access the “C. Format” display. 3) Press the > button to edit “backup files.” The +/– buttons are used to change the value. 4) To initiate the formatting procedure, press the REC button. The display will read:

“Formatting.” 5) When the card is formatted, the display will read “Completed.” The normal display will return automatically. TBS21 © 1995 Roland Corporation U.S., 7200 Dominion Circle, Los Angeles, CA 90040 Faxback # 20049 2/96 NQPSMTR® & :4C@ &2>A=6C