NQPSMTR Supplemental Notes JUNO-60 No ROM reset. JUNO-106 No ROM reset. JV-30 Press CHORUS and REVERB (above INITIALIZE) simultaneously. Press VALUE UP (^) . JV-35 Press CONTROL and MASTER simultaneously. Use PARAMETER UP (^) and DOWN (v) to select ALL. Press VALUE UP (^). JV-50 Press CONTROL and MASTER simultaneously. Use PARAMETER UP (^) and DOWN (v) to select ALL. Press VALUE UP (^). JV-80 Power on while holding NUMBER 8 (also labeled PERFORM 16 and CAPS). Press ENTER and then press WRITE. JV-90 Power on while holding NUMBER 8 (also labeled PERFORM 16 and CAPS). Press ENTER and then press WRITE. JV-880 Press UTILITY, then use the DATA dial to select FACTORY PRESET. Press ENTER twice.
JV-1000 Power on while holding NUMBER 8 (also labeled PERFORM 16 and CAPS). Press ENTER, then press WRITE. JV-1080 Press UTILITY. Cursor down once, then cursor right three times to select FACTORY PRESET. Press ENTER twice, then press UTILITY. JV-2080 Press UTILITY. Press F6 twice to select MENU 3. Press F1. Then press F6. If necessary, use the VALUE DIAL to turn Memory Protect OFF and press F6 twice. JW-50 Press TUNE/FUNCTION. Press F5 (FACTORY), then F4 (JW RESET), then F3 (GS RESET), then F4 (YES). JX-1 Power on while holding WRITE and FLUTE. JX-3P No ROM reset. JX-8P No ROM reset. JX-10 No ROM reset. JX-305 Press UTILITY. Use PAGE to select Factory Preset and press ENTER.
Use PAGE to select ALL and press ENTER twice. KR-33 The unit resets each time you turn it on. KR-55 Hold MIDI/FUNC and press CARD. Hold both VARIATION buttons for 5 seconds. KR-100 The unit resets each time you turn it on. KR-350 While holding LOAD and SAVE, press WRITE. KR-370 The unit resets each time you turn it on. KR-500 While holding FROM and TO, press WRITE. KR-570 While holding PART VOLUME ACCOMP, press TRACK 2 and 4 buttons (Composer section) simultaneously. Press PART VOLUME ACCOMP repeatedly to get FACTORY SETUP LOAD in the window. After loading is complete, power off and then back on. KR-650 While holding LOAD and SAVE, press WRITE.
KR-770 While holding PART VOLUME ACCOMP, press TRACK 2 and 4 buttons (Composer section) simultaneously. Press PART VOLUME ACCOMP repeatedly to get FACTORY SETUP LOAD in the window. After loading is complete, power off and then back on. KR-3000 While holding FROM and TO, press WRITE. KR-3500 While holding LOAD and SAVE, press WRITE. KR-4500 While holding LOAD and SAVE, press WRITE. © 1998 Roland Corporation U.S. Re-initialization Procedures Faxback # 90006 Page 4 of 8