Ramsey Electronics · RXD433 · 8 pp.

Ramsey RXD433 Wireless RF Link Receiver/Decoder Module Instruction Manual PDF

Related manuals

Document text

WIRELESS RF LINK RECEIVER/DECODER MODULE Ramsey Electronics Model No. RXD433 Need a data transmitter or receiver for your remote wireless application? These compact units are perfect for any project; car alarms, door openers, home security, you name it! • SAW Resonators for high stability – no drift! • Compact size with low current demand. • 433 MHz license free band. • Sensitive superhet receiver with RF LNA. • Automatic tuning – no manual adjustments. • Operates on 5 volts DC. RXD-433 • 1

Page 1

RAMSEY WIRELESS RF LINKS • TXE433 or 916 Transmitter & Encoder Module • RXD916 Data Receiver& Decoder • RX433 or 916 Data Receiver • TX433 or 916 Data Transmitter RAMSEY TRANSMITTER KITS • FM10A, 25B FM Stereo Transmitters • TV6 Television Transmitter • “Cube” TV Transmitters RAMSEY RECEIVER KITS • FR1 FM Broadcast Receiver • AR1 Aircraft Band Receiver • SR2 Short-wave Receiver • AA7 Active Antenna • SC1 Short-wave Converter • LC1 Capacitance/ Inductance Meter RAMSEY AMATEUR RADIO KITS • CPO3 Code Practice Oscillator • DDF1 Doppler Direction Finder • HR Series HF All Mode Receivers • QRP Series HF CW Transmitters • CW700 Micro Memory CW Keyer • QRP Power Amplifiers RAMSEY MINI-KITS Many other kits are available for hobby, school, Scouts and ju kits are always under development.

Write or call for our free R RXD433 WIRELESS RECEIVER/DECODER INSTRUCTION Ramsey Electronics publication No. MRXD433 Revisi First printing: July 1999 COPYRIGHT 1996 by Ramsey Electronics, Inc. 590 Fishers Station Drive, 14564. All rights reserved. No portion of this publication may be copied or d written permission of Ramsey Electronics, Inc. Printed in the United States RXD-433 • 2 RXD-433 • 2

Page 2

THE RXD433 This wireless RF receiver/decoder has a 4 bit data output that will match the data sent by the encoder, TXE433. The output is CMOS compatible when the unit is run on +5 volts. The demod bandwidth is selectable by the placement of jumpers on the circuit board. The table on the schematic shows jumper positions for different bandwidths. Narrower bandwidths will give slightly better range at the expense of more limited constraints on battery voltage tolerance over time and more limited operating temperature range. For most applications, the 4800 Hz setting will be best.

The “decoder address select” allows you to use one transmitter to control different receivers by giving each receiver a unique address. The decoder chip has internal pull-up resistors making it a simple matter of grounding the address select pins to match the grounded pins on the transmitter/encoder. These outputs are also CMOS compatible when run on +5 volts. The receiver/decoder unit additionally has a “data valid” output. This output goes high when the “decoder address select” matches the encoder’s address select. This is convenient place to connect a “data valid” LED indicator to show at a glance when the receiver is decoding. The schematic below shows how such an LED can be connected.

ANTENNA CONSIDERATIONS: The simplest antenna consists of a piece of wire approximately 6 to 7 inches long. If you desire more range you can try a ground plane antenna or a Yagi such as the Ramsey 4004 model. The antenna should be tuned for the 433 MHz band for best operation. RXD-433 3

Page 3