30 pp.
Supermicro · SAS815TQ · 12 pp.
Supermicro SAS815TQ Backplane User & Service Manual PDF
Related manuals
15 pp.
18 pp.
16 pp.
16 pp.
17 pp.
128 pp.
112 pp.
Document text
+5V GND GND +12V REV 1.00 SAS815TQ S UPER R JP47 JTAG UPGRADE JP29:9071 RST JP18:BUZZER RESET #2 JP46 R144 JP29 JP18 D3 JP42 JP33 JP34 JP40 JP51 SIDEBAND MH2 M46 M9 M15 JP10 #3 #0 J8 +5V +12V +5V +12V J9 J10 JP26 J7 #1 J6 J5 JP44 2 I C ACT0 ACT1 ACT2 ACT3 ACT IN SAS 815TQ Backplane USER'S GUIDE Rev. 1.0a
SAS 815TQ Backplane User's Guide The information in this User’s Manual has been carefully reviewed and is believed to be accurate. The vendor assumes no responsibility for any inaccuracies that may be contained in this document, makes no commitment to update or to keep current the information in this manual, or to notify any person or organization of the updates. Please Note: For the most up-to-date version of this manual, please see our web site at www.supermicro.com. SUPERMICRO COMPUTER reserves the right to make changes to the product described in this manual at any time and without notice.
This product, including software, if any, and documenta- tion may not, in whole or in part, be copied, photocopied, reproduced, translated or reduced to any medium or machine without prior written consent. IN NO EVENT WILL SUPERMICRO COMPUTER BE LIABLE FOR DIRECT, INDIRECT, SPECIAL, INCIDENTAL, SPECULATIVE OR CONSEQUENTIAL DAMAGES ARISING FROM THE USE OR INABILITY TO USE THIS PRODUCT OR DOCUMENTATION, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. IN PARTICULAR, THE VENDOR SHALL NOT HAVE LIABILITY FOR ANY HARDWARE, SOFTWARE, OR DATA STORED OR USED WITH THE PRODUCT, INCLUDING THE COSTS OF REPAIRING, REPLACING, INTEGRATING, INSTALLING OR RECOVERING SUCH HARDWARE, SOFTWARE, OR DATA.
Any disputes arising between manufacturer and customer shall be governed by the laws of Santa Clara County in the State of California, USA. The State of California, County of Santa Clara shall be the exclusive venue for the resolution of any such disputes. Supermicro's total liability for all claims will not exceed the price paid for the hardware product. Manual Revision 1.0 Release Date: November 1, 2006 Unless you request and receive written permission from SUPER MICRO COMPUTER, you may not copy or otherwise reproduce/distribute any part of this document. Information in this document is subject to change without notice.
Other products and companies referred to herein are trademarks or registered trademarks of their respective companies or mark holders. Copyright © 2005 by SUPER MICRO COMPUTER INC. All rights reserved. Printed in the United States of America ii
Safety Information and Technical Specifi cations Table of Contents Chapter 1: Safety Guidelines 1-2 General Safety Guidelines ............................................................................... 1-1 1-1 ESD Safety Guidelines .................................................................................... 1-1 1-3 An Important Note to Users ............................................................................. 1-1 Chapter 2: Jumper Settings and Pin Defi nitions 2-1 Front Connectors and Jumpers ....................................................................... 2-1 2-2 Front Connector Pin Defi nitions ......................................................................
2-2 2-4 Rear Connectors and LED Indicators ............................................................ 2-5 2-3 Front Jumper Locations and Pin Defi nitions ................................................... 2-4 iii
SAS 815TQ Backplane User's Guide Notes iv