SBI-7127RG-E Blade Server Module User’s Manual 3-4 Onboard Battery Installation A battery is included on the mainboard to supply certain volatile memory components with power when power has been removed from the blade module. If this battery dies, it must be replaced with an equivalent CR2032 Lithium 3V battery. Dispose of used batteries according to the manufacturer's instructions. See Figure 3-12 for a diagram of installing a new onboard battery. Warning: There is a danger of explosion if the onboard battery is installed upside down, which reverses its polarities. Figure 3-12.
Installing the Onboard CR2032 Battery Lithium Battery Battery Holder 3-5 Memory Installation The mainboard of each blade unit must be populated with DIMMs (Dual In-line Memory Modules) to provide system memory. The DIMMs should all be of the same size and speed and from the same Super Micro authorized manufacturer due to compatibility issues. See details below on supported memory and our web site ( www.supermicro.com/products/superblade for recommended memory. Note: For all SBI-7427 series blades, ONLY VLP (Very low profile) memory can be used. Populating Memory Slots The mainboard of a SBI-7127RG-E blade module has eight (8) memory slots, depending upon the blade model.
For optimized memory bandwidth it is strongly recommended that ALL memory slots in this blade server module be populated by DIMMs. DIMM layout is shown in Figure 3-13 on the next page. 3-10