Chapter 5: BIOS Table 5-10. SuperIO Configuration Sub-menu Table 5-11. Serial Port Console Redirection Sub-menu 5-11 Menu Option Description Super IO Chip This static display shows the name of the Super IO chip installed for your system. Serial Port 1 Configuration This submenu allows you to configure Serial Port 1. Serial Port This setting allows you to Enable or Disable the Serial Port. Change Settings Use this setting to select an optimal setting for the Super IO device to use for the Serial Port. Options include Auto, IO=3F8h/IRQ=4, IO=3F8h/IRQ=3~12, IO=2F8h/IRQ=3~12, IO=3E8h/IRQ=3~12 and IO=2E8h/IRQ=3~12 Serial Port 2 Configuration This submenu allows you to configure Serial Port 2.
Serial Port This setting allows you to Enable or Disable the Serial Port. Serial Port Mode This setting allows you to set the Serial Port Mode to either Serial Over LAN (SOL) or COM. Change Settings Use this setting to select an optimal setting for the Super IO device to use for the Serial Port. Options include Auto, IO=3F8h/IRQ=4, IO=3F8h/IRQ=3~12, IO=2F8h/IRQ=3~12, IO=3E8h/IRQ=3~12 and IO=2E8h/IRQ=3~12 Menu Option Description COM1 Console Redirection Use this setting to Enable or Disable Console Redirection for the COM1 port. Console Redirection Settings This submenu contains Console Redirection settings for the COM1 port.
Terminal Type This setting allows you to select the Terminal Type to use for Console Redirection emulation. Options include ANSI (extended ASCII character set), VT100 (ASCII character set), VT100+ (extends VT100 to support color, function keys, etc.) and VT-UTF8 (uses UTF8 encoding to map Unicode characters onto one or more bytes). Bits per Second This setting selects the serial port transmission speed, which must be matched on the other side. Long or noisy lines may require lower speeds. Options include 9600, 19200, 38400, 57600 and 115200. Data Bits This sets the number of data bits as either 7 or 8. Parity A parity bit can be sent with the data bits to detect some transmission errors.
Options include None (no parity bit), Even (parity bit is 0 if the number of 1’s in the data bits is even), Odd (parity bit is 0 if the number of 1’s in the data bits is odd), Mark (parity bit is always 1) or Space (parity bit is always 0. The Mark and Space Parity do not allow for error detection. Stop Bits Stop bits indicate the end of a serial data packet (a start bit indicates the beginning). The standard setting is 1 stop bit. Communications with slow devices may require more than 1 stop bit. Options are 1 or 2.