SBI-7127RG-E Blade Server Module User’s Manual Table 5-7. SCU Configuration Sub-menu Table 5-8. Thermal Management Configuration Sub-menu Table 5-9. PCIe/PCI/PnP Configuration Sub-menu 5-10 Menu Option Description SCU Devices Use this setting to Enable or Disable Patsburg SCU devices on your system. OnChip SAS Oprom This setting allows you to Enable or Disable onboard SAS option ROM if Launch Storage OpROM is enabled. SCU Port 0~7 These static information displays shows whether each SCU Port is present or not present in your system. Menu Option Description Thermal Management This setting allows you to Enable or Disable Thermal Management in your system.
If enabled, this option will initialize the PCH thermal subsystem device D31:F6. Menu Option Description PCI ROM Priority Use this setting in case of multiple Option ROMs to specify what PCI Option ROM to launch. Options include Legacy ROM and EFI Compatible ROM. PCI Latency Timer This sets the value to programmed into the PCI Latency Timer Register. Options include 32, 64, 96, 128, 160, 192, 224 an 248.PCI Bus Clocks. Above 4G Decoding This setting allows you to Enables or Disables decoding of 64-bit capable devices in the Above 4G Address Space. This setting is only usable if your system supports 64-bit PCI decoding.
PERR# Generation This setting allows you to Enable or Disable the PCI device to generate a PERR#. SERR# Generation This setting allows you to Enable or Disable the PCI device to generate a SERR#. Maximum Payload Use this setting to set the maximum payload of the PCI Express device or allow the system BIOS to select the value. Options include Auto, 128 Bytes, 256 Bytes, 512 Bytes, 1024 Bytes, 2048 Bytes or 4096 Bytes. Maximum Read Request Use this setting to set the maximum read request size of the PCI Express device or allow the system BIOS to select the value. Options include Auto, 128 Bytes, 256 Bytes, 512 Bytes, 1024 Bytes, 2048 Bytes or 4096 Bytes.
ASPM Support This sets the ASPM Level for your system. Options include Disabled (disables ASPM), Auto (lets BIOS auto configure) or Force L0s (force all links to L0s state). Onboard LAN Option ROM Select This setting allows you to select the onboard LAN option ROM to be either PXE or iSCSI. Note: If iSCSI is selected, LAN1 Option ROM select will cover all other Oboard LANs. Load Onboard LAN 1 Option ROM This setting Enables or Disables onboard option ROM for LAN1. Load Onboard LAN 2 Option ROM This setting Enables or Disables onboard option ROM for LAN2. Network Stack This setting allows you to Enable or Disable the network stack (Pxe and UEFI).