SC-B9580 User's Guide Basic Operations If the direction is different, press Roll Winding Direction to change the setting. D Follow the on-screen instructions. When loading the media in the auto take-up reel unit, press Prepare for Take-up . See the following for information on loading media in the auto take-up reel unit. U “Using the Auto Take-up Reel Unit” on page 40 Using the Auto Take-up Reel Unit C For media that was replaced and the amount of media remaining has already been printed on, press Remaining Amount Management to set the value. The auto take-up reel unit automatically takes up media as it is printed. Press Paper Remaining - Remaining Amount Management , and set it to On .
If this is set to Off , Remaining Amount Management is not performed. Press Remaining Amount and enter the value for the media remaining that has been printed on the leading edge of the media. The auto take-up reel unit for this printer can take up paper in either of the directions shown below. Printed side in Printed side out Taking-up with printed side in places the printed surface on the inside of the roll. Taking-up with printed side out places the printed surface on the outside of the roll. Note: Two functions are enabled when Remaining Amount Management is set to On You can check the procedure in a video on YouTube.
The following two functions give you a rough idea of the amount of media available before printing, making it easier to know when media requires replacement. Epson Video Manuals ❏ Showing Amount of Media Remaining The control panel display shows the approximate amount of media remaining based on the length set for the media and the amount used during printing. ❏ Remaining Alert A warning is displayed when the amount of media remaining reaches a specified level. 40