Chapter 4: System Interface 4-3 Control Panel LEDs The control panel located on the front of the SC111 chassis has up to five LEDs. These LEDs provide critical information related to different parts of the system. This section explains what each LED indicates when illuminated and any action that may be required. Universal Information LED: The Universal Information LED is used to indated t fan failure, power failure, overheat condition, or to identify the unit within a large rack installation. The feature requires a motherboard that supports the Universal Information LED. When this LED blinks red quickly, it indicates a fan failure and when blinking red slowly a power failure.
This LED will be blue when used for UID (Unit Identifier). When on continuously red, it indicates an overheat condition, which may be caused by cables obstructing the airflow in the system or the ambient room temperature being too warm. See the table below for descriptions of the LED states. Figure 4-2: Universal Information LED States Note: Deactivating the UID LED must be performed in the same way it was acti- vated.
(If the UID LED was activated via IPMI, you can only turn the LED off via IPMI and not with the UID button.) 4-3 Universal Information LED States State Indication Fast Blinking Red (1x/sec) Fan Fail Solid Red CPU Overheat Slow Blinking Red (1x/4 sec) Power Fail Solid Blue Local UID Button Depressed Blinking Blue IPMI-Activated UID