Chapter 5 Chassis Setup and Maintenance 5-5 DVD-ROM Drive Installation Some SC113 chassis models include a DVD-ROM, which is usually pre-installed. Installing or Replacing a DVD-ROM Drive 1. Power down the system as described in Section 5-2 and if necessary, remove the server from the rack and pull the mini-bezel (grate) from the DVD-ROM drive bay. 2. Remove the chassis cover. 3. Unplug the drives power and data cables from the motherboard and/or back plane. 4. Unlock the mini-bezel lock scew and remove the mini-bezel from the drive bay. The bezel can be removed by pulling out the hard drive beneath the DVD-ROM, then pulling the mini-bezel forward. 5.
When installing or removing a DVD-ROM drive, the mini-bezel lock screw must be removed and the drive tray must be completely seperated from the chassis. 6. Remove the DVD-ROM from the drive tray by removing the drive screws, then secure the replacement DVD-ROM into the drive tray, using the drive screws. 7. Reattach the drive tray to the chassis by replacing the mini-bezel lock screw, and tightening it from inside the chassis. 8. Reconnect the data and power cables. 9. Replace the chassis cover and power up the system. Drive Screw Mini-Bezel Lock Screw Drive Screws Figure 5-4. Installing the DVD-ROM Drive 5-5