SC113M Chassis Manual C-7 Rear Jumper Locations and Pin Definitions JP29 C98 C98 C137 C137 + C4 C4 #7 #7 J16 J16 MH6 MH6 #6 #6 J14 J14 BUZZER RST BUZZER RST 1 + #4 #4 J10 J10 U18 U18 #2 #2 J7 J7 R259 R259 I2C#1 I2C#1 JP44 JP44 64 64 REV 1.02 REV 1.02 SAS113TQ J5 J5 #0 #0 MH1 MH1 Figure C-2. Rear Jumpers Explanation of Jumpers 3 2 1 To modify the operation of the backplane, jumpers can be used to choose between optional settings. Jumpers create shorts between two pins to change the function of the connector. Pin 1 is identified with a square solder pad on the printed circuit board. Note: On two pin jumpers, "Closed" means the jumper is on and "Open" means the jumper is off the pins.
Connector Pins Jumper 3 2 1 Setting *The buzzer sound indicates that a condition requiring immediate attention has occurred. The buzzer alarm is triggered by the following conditions: 1. Hard drive failure 2. System temperature over 45є Celsius. C-6 JP33 MH5 JP18 MH3 JP+ 11 32V 1GNDGND+5V I2S CB ## 22JP52 JP45 MH4 +12VGNDGND+5V J21P--3323:::ISM2GOCPDIEO SEL + + C6 #5 J12 JP10 + C5 J8#3 4S 9B 4# 81 MH2 339072 J PR 2S 9T 51UPGRADEJ2 6P46 JP51 + C285 J6 JP33 #1 Jumper Settings Jumper Jumper Settings Note JP18 Open: Default Closed: Reset Buzzer reset* JP29 Open: Default Closed: Reset MG9072 chip reset