Appendix C BPN-SAS-113TQ Backplane Specifications I 2 C and SGPIO Modes and Jumper Settings This backplane can utilize I 2 C or SGPIO. SGPIO is the default mode and can be used without making changes to your jumpers. The following information details which jumpers must be configured to use I 2 C mode or restore your backplane to SGPIO mode.
Rear LED Indicator + MH3 MH3 MH4 MH4 MH2 MH2 JP13 JP13 GND GND +5V +5V GND GND +12V +12V +5V +5V GND GND GND GND +12V +12V 5 6 1 + C6 C6 #5 #5 #4 #4 J12 J12 I2C#2 I2C#2 SB#2 SB#2 JP52 JP52 JP45 JP45 JP10 JP10 + C5 C5 2-3:I2C 2-3:I2C 1-2:SGPIO 1-2:SGPIO JP33:MODE SEL JP33:MODE SEL J8 J8 SB#1 SB#1 48 48 33 33 JP51 JP51 9072 RST 9072 RST UPGRADE UPGRADE JP29 JP29 1 2 JP46 JP46 + C285 C285 J6 J6 MH5 MH5 C98 C98 C137 C137 + C4 C4 #7 #7 J16 J16 MH6 MH6 #6 #6 J14 J14 BUZZER RST BUZZER RST 1 + J10 J10 U18 U18 #3 #3 #2 #2 J7 J7 R259 R259 I2C#1 I2C#1 JP33 JP33 JP44 JP44 49 49 64 64 REV 1.02 REV 1.02 SAS113TQ J5 J5 #1 #1 #0 #0 MH1 MH1 D3 #7 #7 MH6 MH6 Figure C-3.
Rear LED C-7 I2C and SGPIO Settings Jumper I2C Jumper Setting SGPIO Jumper Setting (Default) Note JP33 2-3 1-2 Controller ID Rear LED LED State Specification D3 On Overheat or Drive Failure