SC113M Chassis Manual D-5 Rear Connector Definitions 1. Backplane Main Power Connectors The 4-pin connectors, designated JPW1 and JPW2, provide power to the backplane. See the table on the right for pin definitions. 2. SAS3 Connectors JSM1 and JSM2 provide connections for the SAS drive cables. Pins are defined according the SAS standard. 3. NVMe Connectors Two NVMe connectors are used to connect the NVMe drive cables. Each connector controls one NVMe SSD. Pins are defined according the NVMe standard. 4. JTAG CPLD Upgrade Port The JTAG connector is designated J10 and is for manufacturer use only. . 2-2 Main Power 4-Pin Connector Pin# Definition 1 +12V 2 and 3 Ground 4 +5V