Appendix D BPN-SAS3-113A-N2 D-6 Rear Jumpers J11 J12 1 2 3 D46 1 76 100 MH2 MH4 MH3 1 4 JPW2 CG2 CG3 D1 D2 PRESS FIT JSM1 JSM2 D7 TP23 1 4 JPW1 UB12 CG2 CG3 D1 D2 3 2 1 4 J13 PRESS FIT BMC_SMB D7 D8 DESIGNED IN USA REV 1.10 BPN-SAS3-113A-N2 MH5 JP1 JP2 1 3 1 JP1 3 JP2 1 CPLD_RST CPU_SEL J11 J12 BTTN1 BTTN2 CG2 CG3 + + + + + + C35 C39 C40 JSM3 JSM4 A1 A2 B1 B2 C1 C2 D2 D1 PRESS FIT CG1 B7 B8 A7 A8 C8 C7 D8 D7 JTAG 1 6 J10 A1 A2 B1 B2 C1 C2 D1 D2 CG2 CG3 PRESS FIT CG1 B7 B8 C8 A7 C7 D7 D8 A8 U1 25 26 50 R438 75 51 + + C41 C42 A1 A2 B1 B2 C1 C2 CG1 B7 B8 C8 A7 C7 D8 A8 A1 A2 C1 C2 B1 B2 CG1 B7 B8 C8 A7 C7 A8 BAR CODE 1 2 3 MH1 Figure D-2.
Rear Jumpers Explanation of Jumpers Connector Pins 3 2 1 To modify the operation of the backplane, jumpers can be used to choose between optional settings. Jumpers create shorts between two pins to change the function of the connector. Pin 1 is identified with a square solder pad on the printed circuit board. Note : On two pin jumpers, "Closed" means the jumper is on and "Open" means the jumper is off the pins. Jumper 3 2 1 Setting 2-3 Jumper Settings Jumper Settings Note JP1 Not installed Used only by manufacturing JP2 1-2: Connects NVMe#0 to CPU1, and NVMe#1 to CPU2 2-3 (default): NVMe#0 and #1 to single CPU) NVMe mapping to CPU, CPU1 or CPU2 J11, J12 Open Reserved for future applications