Supermicro SC213L — Supermicro SC213L Chassis Series User Manual

SC213L Chassis Manual Full-Height Card Shield Clamp Note : This U model chas­ sis is pictured without the riser card bracket. Low Profile Card Shield Clamp Figure 5-10. Remove an Expansion Card Slot Shield 5. For a full-height extension card, release the clamp that secures all four PCI shields. Looking at the rear of the chassis, this clamp is in the right corner. Unscrew the single screw that secures the clamp and rotate the clamp away from the shields. For a low profile extension card, release the box-shaped clamp that secures all three PCI shields. Looking at the rear of the chassis, this clamp is near the middle, just left of the low profile PCI slots.

Unscrew the single screw that se­ cures the clamp and slide the clamp to the left away from the shields. 6. Insert the expansion card into a slot on the riser card while aligning the expan­ sion card backplate with the open slot in the rear of the chassis. Repeat for other expansion cards if you are installing more than one. 7. Secure the card backplates to the chassis by returning the clamp to the closed position and installing the locking screw. 8. Replace the chassis cover and power up. 5-10