Supermicro SC213L — Supermicro SC213L Chassis Series User Manual

Chapter 5: Chassis Setup and Maintenance the single screw that secures the clamp and rotate the clamp away from the shields. Remove the blank PCI shield that is pre-installed covering the expan­ sion slot in the chassis. 3. Place the UIO card horizontally in the rear left area of the chassis bottom and insert it into the blue UIO slot in the motherboard, while aligning it with slot in the rear of the chassis. 4. Secure the shield to the rear of the chassis with the lever. Installing an Expansion Card for a U Model Chassis 1.

If this is the first expansion card, start by locating the riser card bracket in your chassis accessory bag, and one or two riser cards, which are purchased sepa­ rately. One riser card accomodates the full-height expansion cards and another riser card accomodates the three low profile expansion cards. 2. Power down the system as described in Section 5-2 and remove the cover. 3. Attach the riser card(s) to the riser card bracket using screws. Note that there are different cards for the right and left side of the bracket. 4. Insert the riser card(s) into the motherboard expansion slot(s) while aligning the riser card bracket with the rear of the chassis. Secure the bracket with screws.

Secure the rear end of the riser card bracket to the rear of the chassis with two screws end of the riser card bracket to the fan tray with Secure the front one screw Figure 5-9. Installing the Riser Card Bracket in a U Model 5-9