Supermicro SC213L — Supermicro SC213L Chassis Series User Manual

SC213L Chassis Manual 5-6 Installing Expansion Cards For the LP models, such as SC213LT-563LPB, the chassis slots are vertical and allow the addition of low profile expansion cards. The U models, such as SC213LT- 563UB, allow a Supermicro universal I/O (UIO) card and more expansion cards. The slots are horizontal. The motherboard must be installed before expansion cards. 1. Power down the system as described in Section 5-2 and remove the cover. Installing an Expansion Card for an LP Model Chassis 2. In the rear of the chassis, remove the blank PCI shield that is pre-installed covering the expansion slot. Chassis Expansion Card Slots Figure 5-8. Removing the PCI Shield in an LP Model 3.

Slide the expansion card into the expansion slot on the motherboard while align­ ing it with the chassis slot in the rear of the chassis. 4. Secure the expansion card shield onto the rear of the chassis with a screw. Expansion Cards for a U Model Chassis The U model chassis, such as SC213LT-563UB, accomodates expansion cards us­ ing riser cards. If your motherboard supports a Supermicro universal I/O (UIO) card, the chassis supports an additional three full-height expansion cards and three low profile expansion cards. If the motherboard does not support a UIO, then the chas­ sis supports four full-height expansion cards and three low profile expansion cards. Installing a UIO Card 1.

Power down the system as described in Section 5-2 and remove the cover. 2. Release the clamp that secures all four full-height PCI shields (Figure 5-10). Looking at the rear of the chassis, this clamp is in the right corner. Unscrew 5-8