Chapter 5: Chassis Setup and Maintenance Changing a Redundant Power Supply 1. Determine which power supply needs to be replaced and unplug the power cord to that module. 2. On the back of the unit, push the release tab and pull the power supply out using the handle. 3. Replace with a the same model unit. Push the new power supply module into the power bay until the tab clicks into the locked position. 4. Plug the AC power cord back into the module and the replacment power module will automatically power-up. Installing the Power Distributor The power distributor provides failover and power supply redundancy and is pre-installed in the chassis.
In the rare event that you have to replace the power distributor, follow the steps below. Figure 5-15. Installing the Power Distributor 5-15