Chapter 5: Chassis Setup and Maintenance Heatsinks transfer heat away from the motherboard. The heatsinks on the SC513 chassis vary with DP and UP models. #SNK-P0007 is used on DP systems, #SNKP0011 is used on UP systems. CAUTION! Heatsinks are heavy and must be handled with care. Installing and Removing the Heatsink(s) Figure 5-8: Installing the Heatsink Heatsink Installation Disconnect the chassis from any power source. 1. Do not apply thermal grease to the heatsink or CPU die. The required amount 2. of grease has already been applied. Screw in two screws which are positioned diagonally from one another, for 3. example, Screw No.1 and Screw No.2 as shown above.
Tighten the screws only until they are snug. Do not fully tighen the screws to avoid possible dam age to the CPU. Complete the installation by fully tightening all four screws. 4. Heatsink CPU Motherboard CPU Socket Figure 5-9: Heatsink Installed Removing the Heatsink Unscrew and remove the heatsink screws from the motherboard in the se 1. quence shown on the right of figure 5-8 above. 5-7