Chapter 5: Chassis Setup and Maintenance SC513 chassis includes a slot for one full height/full length expansion card and a riser card. The riser card allows the expansion card to fit within the small 1U form. PCI Slot Setup The expansion card slot does not require a screw to hold the card in place. Riser Card Riser Card Slots Expansion Card Expansion Card Slot Expansion Card Slot Shield with L-Bracket Figure 5-11: Installing the Expansion Card Installing Expansion Cards Disconnect the chassis from any power source, unplug the power supply, lay 1. the chassis on a flat surface and open the cover. Slide the clip upward which secures the temporary expansion card shield in 2.
the expansion card slot on the inside of the chassis. Slide the expansion card slot shield toward the right side of the chassis and 3. remove the shield. Secure the riser card into the riser card slot on the motherboard. 4. Slide the expansion card slot shield with the L-bracket into the expansion 5. card slot and into the port on the riser card. Replace the PCI slot clip to secure the expansion card to the chassis. 6. 5-9