Supermicro SC733 — Supermicro SC733 Chassis Manual: User & Service Guide PDF

SC733 Chassis Manual 4-5 Installing a Peripheral Drive SC733 chassis models have peripheral drive bays, in which an optional drive may be installed. This may be a DVD-ROM, DVD-RW or other device. In the unlikely event that it becomes necessary to replace a peripheral drive, use the following procedure. Adding or Replacing a Peripheral Drive 1. Power down the system, remove the power cord from the rear of the power supply and open the chassis cover as described in section 4-2. 2. Unplug the power and data cables from the motherboard and/or backplane. 3. If you are adding a new peripheral drive: Remove the mini-bezel (grate) from the drive bay. The bezel can be removed by pulling it forward.

4. Push the new drive unit into the slot, until the tab locks into place. 5. Reconnect the data and power cables. 6. Replace the chassis cover, reconnect the power source and power up the system. 4 Figure 4-9: Installing the Peripheral Drive 4-8