Chapter 4: Chassis Setup and Maintenance Motherboard Installation Installing the Motherboard: 1. Review the documentation that came with your motherboard. Become familiar with component placement, requirements, precautions, and cable connec tions. 2. Power down the system, remove the power cord from the rear of the power supply and open the chassis cover as described in section 4-2. 3. Compare the holes in motherboard to those in the chassis, then add or re move standoffs as needed. To do this: A. Place a hexagonal standoff screw through the bottom the chassis. B. Secure the screw with the rounded side up. 4.
Lay the motherboard on the chassis aligning the permanent and optional standoffs 5. Secure the motherboard to the chassis using the rounded, Phillips head screws. Do not exceed eight pounds of torque when securing the mother board. 6. Secure the CPU(s), heatsinks, and other components to the motherboard as described in the motherboard documentation. 7. Connect the cables between the motherboard, backplane, chassis, front pan el, and power supply, as needed. Also, the fans may be temporarily removed to allow access to the backplane ports. Figure 4-11: Installing the Motherboard 4-11