SAS-733TQ Backplane Specifications C-5 Front Connector Pin Definitions Backplane Main Power Connectors (JP10, JP13) Pin Definitions Backplane Main Power 4-Pin Connectors (JP10, JP13) 1. Sideband Header - JP51 You must use the 4-pin power con nectors JP10 and JP13 to provide adequate power to the backplane. See the table on the right for pin definitions. Pin # Definition 1 +12V 2 and 3 Gound 4 +5V 2. Activity LED Header - JP26 Pin Definitions The sideband header is designated JP51. For SAS-II to work properly, connect an 8-pin sideband cable to JP51 as shown on the right. .
Backplane Addressing { SB5 SB6 } Controller ID Reset { SB4 SB2 } GND Backplane ID { SB7 GND { SB3 SB1 } SDA SB0 } SCL No Connection No Connection Sideband Pin Definitions (JP51) 3. 3-pin Fan Header - JP22 Pin Definitions Act In#0 { SB6 } Controller ID The Activity LED header JP26 trans mits signals to indicate the activity sta tus of each SAS slot. For the Activity LED header to work properly, connect a 4-pin LED cable to Pin 1 to Pin 4 of JP26 as shown on the right. See the table on page C-6 for pin definitions. Reset { SB4 SB2 } GND Backplane ID { SB7 GND { SB3 SB1 } SDA SB0 } SCL No Connection No Connection Note 1: "NC" = No connection Note 2:
Connect a 4-pin LED cable to Pin1 - Pin4 of JP26 only. SAS Activity LED (JP26) 4. Front Overheat/Drive Failure LED Indicators - D3/D4 The 3-pin fan header is designated JP22. To prevent overheating, con nect a 3-pin fan cable to JP22. See the table for pin definitions. Note: The fan header uses DC power. Default: Fan disabled. Fan Header Pin Definitions Caution: Fan headers are DC Powered C-5 2 1 4 3 6 5 8 7 10 9 1 6 2 7 3 8 4 9 5 Pin Number Definition 1 2 3 Ground (Black) +12V (Red) Tachometer